Page History
...
With vehicle power OFF, connect ICE programmer AVR Port to JTAG header.
Make sure to check pinout of Programmer, Vehicle and Connector Cable.
Pinout:
3.
...
Fuses
Turn ON vehicle and connect to ATmega Chip using Device Programming (Apply and Read).
Warning |
---|
Check Fuses See Low Level Controller for more information on fuses and first time use |
Here the fuses that deviate from the default that should be set correctly:
Fuse | Correct Setting |
---|---|
HIGH.SPIEN | Unchecked |
HIGH.EESAVE | Optional i.e. checked or unchecked |
LOW.CKDIV8 | Unchecked |
LOW_SUT_CKSEL | Ext. Crystal Osc. 8.0- MHz; Start-up time: 16 CK + 65ms |
4. Flash ATmega
Flash chip using Start without Debugging
Warning |
---|
Turn OFF vehicle after flashing is complete BEFORE disconnecting programmer |
Overview
Content Tools