We already have a NUC image prepared. It was copied onto a SSD which, in combination with an USB stick with Clonezilla, can be used to 'flash' new NUCs.
Install Procedure
- Insert both the SSD (via an USB adapter) and the stick with clonezilla into the NUC and power it on.
- Press F10 to get into the boot menu, and select the image on the clonezilla stick
- The process of using Clonezilla has already been documented here.
- Make sure to select 850_EVO as source - this is the image on the SSD. The NUCs usually use an M2 stick.
Post-installation
- Router settings: You need to register the MAC address of the NUC and set a fixed IP address for it, following the mask 192.168.1.2xx, where xx corresponds to the ID of the NUC. Check if that actually worked after setting it.
- Known hosts: You need to connect to the NUC (ssh guest@192.168.1.2xx, no password required) once on the main computer to store it as known host (you will be requested to do so). Otherwise, uploads using "Deploy Remote" in the LCC won't work.
- LCC test: Boot the NUC (connected to the network via LAN) and see if it appears as being online in the LCC
Overview
Content Tools